Kess v2 is the most popular ECU programming tool, and the latest kess 5.028 update of v5.017
KESS V5.028 introduction :
KESS V2 software V2.34 with firmware V5.028
KESS 5.028 Master - a professional tool for chip-tuning ECU
KESS V2 supports all the main CAN / J1850 / K-LINE protocols and is designed to work with ECUs of cars, motorcycles and freight vehicles via a diagnostic connector (in the rarest cases, the computer has to be removed for reading on the table).
Kess 5.028 Master - the record holder for the number of supported ECUs, supports the latest ECUs (including those from 2016 vehicles) EDC17, MEV17, MED17, ACDelco Exx, Delphi DCM 3.7, Siemens Simos 10.x with the new Infenion Tricore and Renesas processors and other control units for the engine and automatic transmission (including Mercedes EGS and VW / AUDI DSG series DQ200 and DQ250).
The absolute majority of the computers are programmed via the diagnostic connector. Also, full support for the J1850 protocol is implemented, which now allows programming Ford cars and others using the j1850 (Ford Visteon EECV and others). The device works in conjunction with K-Suite software.
The interface of the software is very clear and easy to use. For each ECU, there is a detailed system of prompts, and if required - a connection scheme "on the table". For most ECUs, a reset of the checksum of the firmware is supported. For C167 / ST10xxx / Tricore TC17xx / family processors, it is possible to work in boot mode.
Kess v2 5.028 Master is one of the most reliable and safe in the workloader and has the function of automatic backup and recovery of the computer. Also, the device constantly monitors the level of charge of the car battery and in the event of a voltage drop in a timely manner will tell you about it. The device can read-write to / from the calibration ECU, or a full flash image (where available) to the user's choice. For read-write in a number of supported blocks, it is possible to manually adjust the exchange rate with the computer. In the same way, the Kess 2 Master loader has the function of reading and erasing errors in some computers and the reset function of the flash programming counter for the EDC16, EDC17, MED17 control units.
